Santon 94.050.001 Aquaheat White Multipoint Unvented Undersink Water Heater 7Ltrs 2.2kW

Element
Alloy sheathed element, incorporated into an easily removable heater plate, should replacement be necessary.
Inner Container
Heavy gauge copper suitable for a maximum working pressure of 6 bar (pressure tested to 15 bar). A minimum supply pressure of 1 bar is recommended.
Outer Casing
The main body is substantial gauge sheet steel, anti-corrosion treated, and finished in white stoved enamel. End covers are moulded in grey ABS. The back has three fixing points for wall mounting.
Insulation
Approved CFC/HCFC free (ODP ZERO) polyurethane foam.
Expansion Relief Valve
This is supplied with the heater and MUST be fitted with every installation. It is set at 6 bar.
A temperature and pressure relief valve can be used (order ref. ALK06).
Expansion/Pressure Kits
If the inlet water pressure is above 4.1 bar, it is essential that kit ALK04 is also installed with the heater. This kit comprises expansion vessel, non-return valve and pressure reducer/strainer.
If the inlet pressure is guaranteed to be below 4.1 bar where full expansion back down the mains is not possible, kit ALK05 must be installed (comprises expansion vessel and nonreturn valve.)
Thermostat
Rod type, adjustable from 10°C to 70°C with integral, manually resettable, over temperature cut-out.
Plumbing Connections
Inlet and outlet are 15mm copper tails.
An expansion relief valve is supplied with the unit and must be fitted to every installation.
The relief valve discharge pipe must be connected to waste (drain) via a tundish. The drain pipe from the tundish must fall continuously and be 22mm diameter copper pipe. It must discharge in a visible and safe place. The pipe must not be reduced in bore or blocked under any circumstances and should be protected from frost.
Under no circumstances must hot water or expanded water be allowed to contaminate the supply to a cold water draw off.
Electrical
This unit is supplied with 1 metre of 3 core cable fitted.
The installation must comply with BS 7671 ‘Requirements for electrical installations’ (IEE Wiring Regulations). It must be fully earthed and permanently connected to the electrical supply through a double pole linked isolating switch with minimum breaking capacity suitable for the loading.
Approvals
BEAB Approved.
WRAS Approved.
UK manufactured in a BS EN ISO 9001:2008 registered factory.
Guarantee
Two year product guarantee, from date of purchase, with on-site service support. Full details are contained in the Installation Instructions supplied with each unit.

Delivery Costs

Our standard delivery charge to UK mainland addresses is £5.49 ex-VAT.

Take advantage of FREE* Delivery when you spend over £50 (per order) ex-VAT.

*Delivery charges to JE, GY, TR, BT, IM, IV, HS, KW, ZE and certain PA post codes are £12.00 ex-VAT.

Solar Panels, Batteries and Inverters

Due to their size all solar panels, batteries and inverters orders up to 25 qty will be despatched on a pallet and incur a £120** ex-VAT delivery charge.

**£180 ex VAT to JE, GY, TR, BT, IM, IV, HS, KW, ZE and certain PA post codes.

Click here to find out more.

Stock Availability and Delivery

In-stock items for delivery to you within 1-2 working days. We will contact you if we do not have all of your items in stock.

Items kept in our remote warehouse or ordered from the supplier. We will advise you if it will take any longer than the typical 2-4 working days.