Santon 94.020.015 EV2008 3 White Instantaneous Handwash Water Heater With Single-Turn Rotary Dial 3kW 240V

Controls
Combined On/Off and temperature control knob with large finger/ thumb grip for ease of use.
Casing
The unit is splashproof and is encased in a white moulded ABS plastic cover which conceals both the plumbing and electrical connections.
Inner Container
Glass filled nylon cylinder complete with Inlet and Outlet connections, pressure relief device and heating element.
Pressure Relief
A pressure relief device is incorporated in the base of the container to prevent high pressure build-up if the handwash unit should become blocked or frozen.
Ingress Protection
IPX5.
High Temperature Cut-out
A pre-set safety cut-out set at 52ºC prevents overheating should abnormal conditions arise - this will re-set at 42ºC. In addition there is a failsafe, second stage protection, which is not re-settable and cuts out at 92ºC.
Temperature Stabiliser
An automatic temperature stabiliser ensures that the temperature of the water is maintained across the water pressure range.
Pressure Range
Min. 1.0 bar. Max. 7.0 bar.
Connections
15mm female ‘Push Fit’ connection at base of unit for bottom or rear (concealed) connection.
Outlet
Stainless Steel swivel spout with spray outlet (200mm).
Spray Plate
Low velocity spray giving consistent spray pattern, for efficient hand-washing, over a range of flow rates.
Fixing
Base plate is secured to wall by 2 fixing screws, after which electrical and plumbing connections are made. Spout and front cover are then attached. 2 screws secure the front cover.
Electrical
Special requirements of the IEE wiring regulations should be observed when installing in bathrooms. Units must be permanently connected to the electrical supply through a double-pole linked isolating switch.
EV 2008/3 (3.1kW) can be supplied from a ring final circuit via fused spur with a double pole linked isolating switch with a 13A minimum breaking capacity. Cable:- 1.5 - 2.5mm².
EV 2008/7 (7.2kW) requires a dedicated circuit switch rated at 30A minimum. Cable:- 6.0mm².
Approvals
BEAB and KIWA approved.
Manufactured in a BS EN ISO90002 registered factory.
Guarantee
2 years product guarantee, from date of purchase, with on-site service support.
Full details are contained in the installation instructions supplied with each unit.

Delivery Costs

Our standard delivery charge to UK mainland addresses is £5.90 ex-VAT.

Take advantage of FREE* Delivery when you spend over £100 (per order) ex-VAT.

*Delivery charges to JE, GY, TR, BT, IM, IV, HS, KW, ZE and certain PA post codes are £12.00 ex-VAT.

Solar Panels, Batteries and Inverters

Due to their size all solar panels, batteries and inverters orders up to 50 qty will be despatched on a pallet and incur a £120** ex-VAT delivery charge.

**£180 ex VAT to JE, GY, TR, BT, IM, IV, HS, KW, ZE and certain PA post codes.

Click here to find out more.